Siirry sisältöön

Zenec ZE-RVC55LP

Rear View Camera, Universally Mountable

Ei varastossa
Tuoteno: 944889


The ZENEC license plate cam model ZE-RVC55LP was developed for use on almost any license plate holder, allowing retrofitting of a great variety of vehicles. The picture can be outputted as normal or mirror image, for mounting and utilization of this model as front or as rear view camera.
With two different mounting options, the ZE-RVC55LP is ideal for use on almost any vehicle.
This product is compatible with a wide variety of 2-DIN A/V receivers of the aftermarket and the ZENEC E>GO product line up, including ZENEC 2-DIN infotainers and naviceivers.
Compact, high-resolution camera for license plate holder
System design allows front- or rear-mounting and use
Normal or mirror image picture output selectable
Detailed high contrast picture ideally suited for twilight conditions
Separable 3-part system cable, with cable lengths of 0.7 m + 7.0 m + 0.7 m
Two different mounting solutions included in set content
Image device: 1/4” / 6.4 mm Aptina ASX340 CMOS sensor
Lens focal length: F 1.5
TV system: NTSC / 60 Hz
View angles: 180°(D) x 140°(H) x 90°(V)
Native sensor resolution: 680 (H) x 512 (V) pixels
Resolution of video-out: > 420 TV lines
Frame rate: 60 fields/sec.
Signal to noise ratio: > 48 dB
Light sensitivity: 0.5 Lux/F1.2/50IRE
Video output: 1.0 Vp-p, 75 ohms CVBS
White balance: Auto
Backlight compensation: Auto
Gamma correction: 0.45
Gain control: Auto
Sync system: Auto
Power supply: DC 6 - 16V
Current consumption: 40mA (DC12V) / ≤ 480mW
IP protection rating: IP69K
Operating temperature: -30°C~+75°C
Dimensions: screwed 20 x 32 x 32 mm (H x W x D), glued 37 x 32 x 32 mm (H x W x D)




Tuote on siirretty ostoskoriin